Why Did My Microwave in Patna Stop Heating the Day After the Power Came Back?
It is one of the most common questions we get from Patna kitchens, and the timing is not a coincidence. When supply returns after a summer cut it often comes back with a spike, and the microwave, sitting plugged in and on standby, takes it on the chin. The main fuse blows, or the control board loses a regulator, or the high-voltage diode shorts. The oven lights up, the turntable spins, the timer counts down, and the food stays cold. Sometimes it is simpler: the voltage has come back at 190 volts and the magnetron will not fire until the supply steadies. Either way, the fault is Patna's grid as much as the oven.
The four household stories below come from the kind of microwave repair calls AC Care India takes across Patna, and each one ends with a lesson that applies to most homes here.
Four Patna Kitchens and What They Taught Us
A high-floor flat in Kankarbagh with a shared socket
A family on the seventh floor ran the microwave, the mixer and the electric kettle from one multi-plug on the kitchen counter. On a summer evening with voltage already low, the microwave's transformer drew its start current through a cord shared with the kettle, the plug heated, and the oven's fuse went. The lesson: a microwave pulls well over a kilowatt and needs its own earthed 16-amp socket, not a strip shared with heating appliances, especially when the colony's voltage is sagging.
An old house in Patna City with thin wiring
In a ground-floor kitchen near Gulzarbagh the microwave gave a mild shock when touched with wet hands. The wiring was decades old, the earth pin on the socket was unconnected, and the oven's cavity had a small leak to the body through a damp door switch. The lesson: in older Patna housing, check the earth before you blame the oven. We tested the socket, found no earth, and would not switch the oven on until the wiring was corrected.
A joint-family kitchen in Boring Road during Chhath
With thekua and kheer being prepared for a large family, the convection oven ran for hours on end in a kitchen already hot from the gas. The convection fan motor, its bearings dry after years of dusty summers, seized, and the heater element overheated and failed. The lesson: convection mode in a hot Patna kitchen needs ventilation space around the oven and a rest between long bakes; a fan that has started to whine should be seen before the festival rush, not after.
A rental flat on Bailey Road with a sparking oven
Tenants inherited an oven whose mica waveguide cover was stained with years of someone else's curry splashes. One evening it began to arc and burn, and the cavity paint beneath it blistered. The lesson: sparking is almost always a dirty or damaged mica sheet or chipped cavity paint, both cheap to fix, but ignoring it risks the magnetron. Wipe the cavity after every use and have the mica replaced at the first flash.
Low Voltage, Stabilisers and the Magnetron
A microwave's magnetron needs the full high voltage from its transformer to fire, and that transformer is fed from the mains. When Patna's evening supply sags to 180 or 190 volts, the transformer's output drops with it, and the oven may run the fan and turntable yet produce almost no heat. People then assume the magnetron has failed, when it has only been starved. A stabiliser of the right rating on the kitchen line, or at least a wait until the voltage recovers, settles the question before any part is ordered. The reverse problem is the spike. A sudden high voltage when supply returns after a cut punches through the high-voltage diode or the control board's regulator, and that damage is real. Our technicians measure the socket voltage first on every call and will not condemn a magnetron on a low-voltage evening.
Checks to Make Before You Call
- Confirm the socket is live and the MCB has not tripped; a lamp or phone charger will tell you.
- Read the stabiliser or check a neighbour: if the colony's voltage is low, wait and try again.
- Press the door firmly closed; a latch filled with dust or a warped door stops the oven from starting.
- Heat a cup of water for one minute. Warm means the oven works and the problem is elsewhere; cold means the high-voltage section needs a technician.
- Look inside for burn marks on the mica cover beside the cavity wall; that is the sparking source.
- Do not open the back cover. The capacitor behind it can deliver a dangerous shock long after the plug is pulled.
Faults, Causes and Repairs
| Symptom | Usual Cause in Patna | Our Repair |
|---|---|---|
| Runs but does not heat | Magnetron, HV diode or capacitor failed; HV fuse blown after surge | Discharge safely, test HV circuit, replace failed part |
| Completely dead | Main fuse or control board damaged by restart spike | Replace fuse, repair or replace PCB |
| Sparks inside | Grease-stained mica, chipped paint, metal object | Replace mica, repaint cavity with food-safe coating |
| Works only when door pressed | Worn interlock switches, dust in latch | Replace switches, clean and adjust door |
| Turntable stuck | Motor seized by dust and grease, broken coupler | Replace motor or coupler |
| Touch panel unresponsive | Heat and dust under membrane; monsoon damp | Replace panel |
| Stops mid-cycle, restarts later | Overheating in cramped kitchen, failing cooling fan | Clean vents, replace fan, advise placement |
| Convection weak or uneven | Failed heater element or convection fan | Replace element or fan motor |
What a Microwave Service Includes
- Confirm the symptom and note whether it started after a power cut, a storm or a spill.
- Check the socket for voltage and earth before anything else.
- Unplug and discharge the high-voltage capacitor with an insulated tool. This is never skipped and never a DIY step; the capacitor holds a dangerous charge even hours after unplugging.
- Inspect the door, hinges, latch and interlock switches.
- Test the main fuse, HV fuse, diode, capacitor and transformer.
- Check magnetron continuity and the mica cover and cavity paint.
- Test the turntable motor, cooling fan, and on convection and grill models the elements and convection fan.
- Reassemble, heat a measured cup of water and compare against rated output.
- Explain findings, give a written quote and the warranty terms before any part is fitted.
Habits That Keep a Patna Microwave Alive
- Switch the oven off at the wall during long power cuts so the restart spike does not reach it; a small surge protector on the kitchen line is cheap insurance.
- Give it its own earthed socket, not a multi-plug.
- Leave ten centimetres of clear space behind and above, more in a kitchen that reaches 40°C in May.
- Wipe the cavity and the mica cover after every use; dried masala is what sparks.
- Dust the vents monthly in summer, when Patna's dust finds every grille.
- Do not run convection mode for hours without a break in the festival season.
- Never operate the oven with a door that does not close firmly.
Brands We Repair in Patna
Solo, grill and convection models from Samsung, IFB, Bajaj, Morphy Richards, Panasonic, Whirlpool and Godrej are all familiar to our technicians, who carry magnetrons, diodes, capacitors, fuses, mica sheets, door switches and turntable motors for the common models. To be clear, AC Care India is an independent multi-brand appliance repair service and not the authorised service centre of any microwave manufacturer; brand names are given only to identify the ovens we handle, and an oven still under the maker's warranty should go to the brand first.
Patna Localities We Cover
Boring Road, Sri Krishna Puri, Patliputra Colony, Buddha Colony, Kidwaipuri, Fraser Road, Exhibition Road, Gandhi Maidan, Kankarbagh, Rajendra Nagar, Lohanipur, Kadamkuan, Mahendru, Patna City, Gulzarbagh, Bailey Road, Raja Bazar, Khajpura, Saguna More, Jagdeo Path, Danapur, Gola Road, Ashiana Nagar, Rajiv Nagar, Anisabad, Gardanibagh and Phulwari Sharif.
What Makes AC Care India Different
- Verified technicians trained on high-voltage safety and on reading surge damage.
- A written quote before any part is replaced.
- Warranty on the repair and on fitted components.
- Genuine or disclosed compatible magnetrons, diodes and boards.
- Same-day or next-day visits in most of the city.
- Plain advice when a ten-year-old oven with a rusted cavity should be replaced rather than repaired.
Book Microwave Repair in Patna
Call or WhatsApp 9266608882 or book online through this page. Tell us your locality, the brand and model type, and whether the fault followed a power cut, and we will send the nearest technician with the likely parts. In a city where the supply comes back with a jolt, a surge protector, a dedicated socket and a clean mica cover will keep a microwave working for years; for everything else, we are a call away.



